| MTPX Plus Series |
|
| Video |
|---|
| Routing | |
| MTPX Plus 816 | 8 x 16 matrix, 3 x 1 local |
| MTPX Plus 128 | 12 x 8 matrix, 4 x 2 local |
| MTPX Plus 168 | 16 x 8 matrix, 3 x 1 local |
| MTPX Plus 1616 | 16 x 16 matrix, 3 x 1 local |
| MTPX Plus 1632 | 16 x 32 matrix, 6 x 2 local |
| MTPX Plus 3216 | 32 x 16 matrix, 6 x 2 local |
| MTPX Plus 3232 | 32 x 32 matrix, 6 x 2 local |
| Gain | Unity ±1 dB |
| Crosstalk | |
| 128 models | -76 dB @ 1 MHz, -55 dB @ 10 MHz, -45 dB @ 30 MHz, -30 dB @ 100 MHz |
| 816, 168, 1616 models | -80 dB @ 1 MHz, -71 dB @ 5 MHz, -55 dB @ 10 MHz, -45 dB @ 30 MHz, -37 dB @ 100 MHz |
| 1632, 3216, 3232 models | -90 dB @ 1 MHz, -76 @ 5 MHz, -72 dB @ 10 MHz, -60 dB @ 30 MHz, -50 dB @ 100 MHz |
| Switching speed | 200 ms (max.) |
|
| Video input — local |
|---|
| Number/signal type | 3, 4, or 6 analog RGBHV, RGBS, RGsB, RsGsBs, component video (bi-level and tri-level), S-video, composite video |
| Connectors | 3, 4, or 6 female 15-pin HD |
| Nominal level | 1 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.3 Vp-p for C of S-video |
| Impedance | 75 ohms ±5% |
| Horizontal frequency | 15 kHz to 130 kHz |
| Vertical frequency | 30 Hz to 150 Hz |
| Return loss | <-30 dB @ 5 MHz |
| DC offset (max. allowable) | 250 mV |
|
| Video input — main (see transmitters' output specifications) |
|---|
| Number/signal type | 8, 16, or 32 proprietary analog signals |
| Connectors | 8, 16, or 32 (depending on configuration) female RJ-45 connectors |
|
| Video output — local |
|---|
| Number/signal type | 1 or 2 analog RGBHV, RGBS, RGsB, RsGsBs, component video (bi-level and tri-level sync), S-video, composite video |
| Connectors | 1 or 2 female 15-pin HD |
| Nominal level | 0.7 Vp-p for RGB |
| Impedance | 75 ohms ±10% |
| Return loss | <-30 dB @ 5 MHz |
| DC offset | <±40 mV with input at 0 offset |
|
| Video output — main (see receivers' input specifications) |
|---|
| Number/signal type | 8, 16, or 32 proprietary analog signals |
| Connectors | 8, 16, or 32 (depending on configuration) female RJ-45 connectors |
|
| Sync — local inputs and outputs only |
|---|
| Input type | RGBHV, RGBS, RGsB, RsGsBs |
| Output type | See receiver specifications (on Web site). |
| Standards | NTSC 3.58, NTSC 4.43, PAL, SECAM |
| Input level | 3.5 V to 5.0 Vp-p, DC |
| Output level | See receiver specifications (on Web site). |
| Input impedance | 611 ohms ±5% |
| Output impedance | 105 ohms ±30 ohms |
| Max. output voltage | ≤4.0 VDC with a 2k ohm load |
| Max. rise/fall time | 4 ns |
| Polarity | Positive or negative |
|
| Audio |
|---|
| Routing | |
| MTPX Plus 816 | 8 x 16 mono matrix, 3 x 4 local |
| MTPX Plus 128 | 12 x 8 mono matrix, 4 x 2 local |
| MTPX Plus 168 | 16 x 8 mono matrix, 3 x 4 local |
| MTPX Plus 1616 | 16 x 16 mono matrix, 3 x 4 local |
| MTPX Plus 1632 | 16 x 32 mono matrix, 6 x 8 local |
| MTPX Plus 3216 | 32 x 16 mono matrix, 6 x 8 local |
| MTPX Plus 3232 | 32 x 32 mono matrix, 6 x 8 local |
| Gain (local inputs and outputs) | Unbalanced output: 0 dB ±2 dB with a 600 ohm load, single ended
Balanced output: +6 dB ±2 dB with a 600 ohm load, single ended |
| Frequency response | 20 Hz to 20 kHz, ±1 dB |
| THD + Noise | ≤0.15% @ 1 kHz at nominal level |
| S/N | >70 dB at maximum output (unweighted) |
| CMRR | >43 dB @ 20 Hz to 20 kHz |
|
| Audio input — local |
|---|
| Number/signal type | 3, 4, or 6 stereo, balanced/unbalanced |
| Connectors | (3, 4, or 6) 3.5 mm captive screw connectors, 5 pole |
| Impedance | >10k ohms unbalanced |
| Nominal level | +4 dBu (1.23 Vrms), -10 dBV (316 mVrms) |
| Maximum level | +18 dBu, (unbalanced) at 1% THD+N |
| NOTE | 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu |
|
|
| Audio input — main (see transmitters' output specifications) |
|---|
| Number/signal type | 8, 16, or 32 proprietary analog signals |
| Connectors | 8, 16, or 32 (depending on configuration) female RJ-45 connectors |
|
| Audio output — local |
|---|
| Number/signal type | 2, 4, or 8 dual mono, balanced/unbalanced |
| Connectors | (2, 4, or 8) 3.5 mm captive screw connectors, 5 pole |
| Impedance | 50 ohms unbalanced, 100 ohms balanced ±10% |
| Gain error | ±2 dB channel to channel |
| Maximum level (≥10k ohms) | +16 dBu, balanced or unbalanced at 1% THD+N |
| Maximum level (600 ohm) | +15 dBm, balanced or unbalanced at 1% THD+N |
|
| Audio output — main (see receivers' input specifications) |
|---|
| Number/signal type | 8, 16, or 32 proprietary analog signals |
| Connectors | 8, 16, or 32 (depending on configuration) female RJ-45 connectors |
|
| Control/remote — switcher host control |
|---|
| Serial host control ports | |
| MTPX Plus 128 | 1 RS-232, rear panel 3.5 mm captive screw connector, 3 pole |
| All other models | 1 RS-232 or RS-422, rear panel female 9-pin D connector
1 RS-232 front panel 2.5 mm mini stereo jack |
| Baud rate and protocol | 9600 baud (default), 19200, 38400, and 115200 (adjustable); 8 data bits; 1 stop bit; no parity |
| Serial control pin configurations |
| 9-pin female D connector | RS-232: 2 = Tx, 3 = Rx, 5 = GND
RS-422: 2 = Tx-, 3 = Rx-, 5 = GND, 7 = Rx+, 8 = Tx+ |
| Mini stereo jack | Tip = Tx, ring = Rx, sleeve = GND |
| Captive screw connector | RS-232: 1 = Tx, 2 = Rx, 3 = GND |
| USB control ports | |
| MTPX Plus 128 | 1 front panel female mini USB B |
| USB standards | |
| MTPX Plus 128 | USB 2.0, low speed |
| Ethernet control port | 1 RJ-45 female connector |
| Ethernet data rate | 10/100Base-T, half/full duplex with autodetect |
| Ethernet protocol | ARP, ICMP (ping), IP, TCP, UDP, DHCP, HTTP, SMTP, Telnet |
| Default settings | Link speed and duplex level = autodetected
IP address = 192.168.254.254
Subnet mask = 255.255.0.0
Gateway = 0.0.0.0
DHCP = off |
| Web server | Up to 200 simultaneous sessions
16 MB nonvolatile user memory |
| Program control | Extron control/configuration program for Windows®
Extron Simple Instruction Set™ (SIS™)
Microsoft® Internet Explorer® version 6 or higher, Telnet |
|
| Control/remote — external device (pass-through, unidirectional, or bidirectional) |
|---|
| Serial control ports | RS-232, 3.5 mm captive screw connectors, 3 pole |
| 3232 and 1632 models | 16 connectors |
| 3216, 1616, 128, and 816 models | 8 connectors |
| 168 models | 4 connectors |
| Baud rate and protocol | Up to 38400 baud, 9600 baud (default); 5-8 data bits; 1 or 2 stop bits; odd, even, or no parity; XON, XOFF, or no flow control |
| NOTE | Protocol is mirrored between the switcher and the receiver. |
|
| Serial control pin configurations | 1 = Tx, 2 = Rx, 3 = GND |
|
| General |
|---|
| Recommended cable type | Shielded or unshielded CAT 5/5e/6/7 or Extron Enhanced Skew-Free™ A/V UTP |
| Power | 100 VAC to 240 VAC, 50-60 Hz, internal |
| 1632, 3216, 3232 models | 220 watts |
| 816, 168, 1616 models | 120 watts |
| 128 model | 73 watts |
| Ambient temperature/humidity | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing |
| Cooling | Fan, left to right (as viewed from the front panel) |
| Thermal dissipation | |
| 128 model | |
| 115 VAC, 60 Hz | 231.1 BTU/hr |
| 240 VAC, 50 Hz | 223.8 BTU/hr |
| 1616 model | |
| 115 VAC, 60 Hz | 348.3 BTU/hr |
| 240 VAC, 50 Hz | 353.0 BTU/hr |
| 3232 model | |
| 115 VAC, 60 Hz | 607.1 BTU/hr |
| 240 VAC, 50 Hz | 595.3 BTU/hr |
| Rack mount | Yes |
| Enclosure type | Metal |
| Enclosure dimensions | Depth excludes connectors, width excludes rack ears. |
| 1632, 3216, 3232 models | 5.25" H x 17.0" W x 9.4" D (3U high, full rack wide)
(13.3 cm H x 43.1 cm W x 23.9 cm D) |
| 816, 168, 1616 models | 3.5" H x 17.0" W x 9.4" D (2U high, full rack wide)
(8.9 cm H x 43.1 cm W x 23.9 cm D) |
| 128 model | 1.7" H x 17.4" W x 12.0" D (1U high, full rack wide)
(4.3 cm H x 44.2 cm W x 30.5 cm D) |
| Product weight | |
| 1632, 3216, 3232 models | 16.0 lbs (7.3 kg) |
| 816, 168, 1616 models | 8.5 lbs (3.9 kg) |
| 128 model | 3.7 lbs (1.6 kg) |
| Shipping weight | |
| 1632, 3216, 3232 models | 26 lbs (ll.8 kg) |
| 816, 168, 1616 models | 18 lbs (9 kg) |
| 128 model | 7 lbs (4 kg) |
| DIM weight (International) | |
| 1632, 3216, 3232 models | 26 lbs (11.8 kg) |
| 816, 168, 1616 models | 18 lbs (9 kg) |
| 128 model | 7 lbs (4 kg) |
| Vibration | ISTA 1A in carton (International Safe Transit Association) |
| Regulatory compliance |
| Safety | CE, c-UL, UL |
| EMI/EMC | CE, C-tick, FCC Class A, ICES, VCCI Class A |
| Environmental | Complies with the appropriate requirements of WEEE. |
| Product warranty | 3 years parts and labor |
| Everlast power supply warranty | 7 years parts and labor |
| NOTE | All nominal levels are at ±10%. |
|
| NOTE | Specifications are subject to change without notice. |
|
| (7.6-021910-D16) |